Dial Gauge Shaft Alignment With Electronic Indicator And Pocket PC

Dial Gauge Shaft Alignment With Electronic Indicator And Pocket PC- BALTECH SA-4200

During repair of dynamic equipment, it is important to perform shaft alignment and balancing. BALTECH SA-4200 is a system for alignment of electric motors with digital electronic indicators on the basis of a pocket computer. The system is designed to perform the shaft alignment of horizontal and vertical machines. During the repair and set-up of the dynamic machines it is recommended to check piping tension, replace bearings, check for soft foot and compensate thermal growth.



Shaft alignment of horizontal electric motors 9-0-3


Check and elimination of soft foot during the alignment of electric motors


Compensation of shaft floating on oil wedge (shaft alignment of sleeve bearings)


Shaft alignment of vertical electric motors 9-0-3


Selection between the alignment methods: radiaxial method or dial indicator method


Built-in digital camera

Technical Specifications

Number of indicators (dial) 2
Sensor type Electronic indicator
Measurement range Not less than 12,5 mm
Measurement accuracy 0,01 mm
Maximum diameter of mating shafts (couplings): - with chains 600
- with magnets (options) Not limited
Rod length 290 mm
Measurement unit Pocket PC
Operation temperature -15oC...+45oC